End mills in a drill press

End mills in a drill press difference between slot drill and end mill The End mill can be used for non captivated Keyways,elongations and counterbores that have a through hole End mills can generally be run faster than the Slot difference between end mill and slot drill So why use an Endmill and not a drill bit? In short, a drill bit moves up and down, and an end mill moves side-to-side (Note: there are endmills

difference between end mill and slot drill M335 - Imperial HSS Slot Drill & End Mill Set - 12 Piece Ø316

difference between port and slot A slot mill has two flutes,an endmill usually has four An endmill will always cut out bigger than its diameter,a slot drill should cut to its diameter  So why use an Endmill and not a drill bit? In short, a drill bit moves up and down, and an end mill moves side-to-side (Note: there are endmills