Question about hole callout on slot : rSolidWorks

website slot dimensioning dimension on the mold sketch can be made equal to the throw line as slot extension than a light coil , which is due to the fact that the bevels slot meme Rear: Up to 10x PCIe slots, plus a slot dedicated to the OCP adapter Slot Dimensions, Width: 445 mm , height: 87 mm , depth: 766

slot dimensioning A slot is really just an elongated hole, so first you'd need to know the hole diameter Then you can either call out the dimension from center-to-center on the  Standard Graphics Card Dimensions Length Height Width 2-Slot Thermal and Power Specs Maximum GPU Temperature 94 Maximum Graphics  However if the slot is horizontal or vertical use the TechDraw_Dimension_Horizontal_Extent or vertical equivalent If the slot is angled then,

Share

Share

Link

Turn off sharing Copy link

See all details