Question about hole callout on slot : rSolidWorks

slot hole dimension   Dan slot demo pragmaticplay

Hello to all,I would like to know if there is a way to dimension a slot in a drawing

The standard clearance in diameter and width of slot for a fastener 18 mm in diameter is 1 1 mm 2 2 mm 3 3 mm 4 4 mm 5  RE: Long-Slotted hole size​​ I am counting on roughly 50% of the shear capacity per bolt They are 12 diameter expoxy anchors into a bond beam

lightning mcqueen slot car A slot is really just an elongated hole, so first you'd need to know the hole diameter Then you can either call out the dimension from center-to-center on the Dimensioning, Continued Slotted holes Dimension slotted holes by width, length, or center points Indicate the end radii but do not dimension them